Table 1 summarizes the available design interface component that can be placed from the FPGA NB2DSK01 Port-Plugin.IntLib, to access and use the SPI Flash memory devices. #Spi serial flash programmer schematic design serial#The SPI Flash memory devices can be found on Sheet 40 ( FLASHSPI_M25PX0.SchDoc, entitled Dual Serial Flash Memory) of the motherboard schematics. These devices, along with all other NB2DSK01 memories, the NanoTalk Controller and the configuration PROM, are covered by the TFT LCD panel. The two M25P80 devices ( U20 and U21) are located on the component side of the board, above the Xilinx Spartan-3 NanoTalk Controller device ( U5). The SPI Flash memory devices can be erased and programmed from within Altium Designer, using the Instrument panel for the NanoTalk Controller. This gives you the ability to 'bootstrap' the FPGA device upon powering-up the NB2DSK01. It can also be used to store the programming file required for implementing a design within the daughter board FPGA. This device can be used from within an FPGA design, as described above.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |